I’ve moved the seat back another 0.5cm, and now it’s at it’s furthest so we’ll see… (it was only at about 3cm back)
Maybe a small sharp edge, but overall I don’t think it was that bad…
As for getting the wires trough, I dislokated the joint and took out the plastic thingie. I taped some fine electrical wire to the end of the black brakecable and just pulled it trough. And then reinserted the brake cable. And assembled everything. Soldered the tripcomp to the electrical wire and was good to go.
To take out the plastic joint thingie you have to take out the screw, and remove the rear brakewires first including the plastic guide thingie and then you can just gently pull it out.
Since I had already dislocated it by accident on the first night I got it, I could go ahead and explore some more. A replacement is already on order (also the side stand & protection velcro’s).