I’ll try to remember to take pictures and do a little writeup when I’m installing the new one.
[update]
A little toptip for mounting the sensor and holder for the tripcomputer.
The rubbers that come with most are not big enough to be mounted on the Strida. The piping is a bit wider then most other bikes. (Unless your set comes with optional rubbers for MTBs).
I broke one, and the other just wasn’t big enough. So off to the DIY-store.
I used a set of plumbing washers of 39x33x3mm. Used 3 to mount the tripcomputer on the middle bad and used 2 to mount the sensor near the backwheel.